Sisterna sucrose esters are produced inJapan, from cane sugar and fatty acids from palm oil. Sisterna sucrose esters are based on vegetable, renewable raw materials (non-GMO), and are easily biodegradable. Sisterna sucrose esters are suitable for Kosher, Halal and Vegan food products.
Upon digestion sucrose esters are hydrolysed to their components, sugar and fatty acids, which are metabolised by the body in a normal way. The caloric value depends on the ratio sugar : fatty acids.
The microbiological contamination of Sisterna sucrose esters is very low (
Sucrose esters are sensitive for high acidity. You can work with the following indicative schedule:
For more information watch our video Emulsion stability.
The type and dosage of Sisterna sucrose esters strongly depend on the application and processing. A common dosage is 0.1% to 1%.
High HLB sucrose esters (Sisterna PS750, SP70 and SP50) are soluble in water.
Medium HLB sucrose esters (Sisterna SP30) are partly soluble in water and partly in oil/fat.
Low HLB sucrose esters (Sisterna SP10 and SP01) are soluble in oil/fat.
The higher the HLB value, the better soluble in water. Sisterna SP70 and PS750 are well soluble in cold water, the latter forming a clear solution.
An instruction video how to dissolve sucrose esters in water can be found here.
Actually in most food products that have fat or oil emulsified in a water phase, and products that contain crystallised sugar or polyols. As we are unique in the high HLB-values, sucrose esters are more commonly used in oil-in-water emulsions. Typical product groups are bakery, dairy, sauces and confectionery.
This depends on the product and processing. As a general rule sucrose esters should be mixed in the water phase and not in the oil phase. High HLB sucrose esters work best (Sisterna SP70, SP50 and PS750). An information video about emulsion stability can be found here.
Sisterna sucrose esters promote sugar crystallisation, which result in speedy crystallisation and smaller crystals. This effect is also shown in sugar-free polyol applications. Dissolve Sisterna SP50 or SP70 in the sugar or polyol solution before crystallisation.
Sisterna F20W acts as a lubricant in tabletting. F20W is a sucrose oligo ester and not permitted in tablets in Europe and USA. Tablets that are exported to Japan can contain Sisterna F20W.
Yes, Sisterna sucrose esters can ensure very small oil droplets (< 1 µm) with only a high shear mixer, provided that you prepare a concentrated emulsion with glycerol as continuous phase. This emulsion can be applied in a food-product later. For more information contact Sisterna.
Yes, sucrose esters with high HLB value strongly decrease the surface tension between water and air, so aeration is facilitated. A high overrun is quickly reached.
Sisterna sucrose esters inhibit growth of gram-positive bacteria and some gram-negative bacteria and some moulds and yeasts. Sucrose esters can't be considered as preservatives, but they can help preventing spoilage by certain micro-organisms. As an example sucrose esters are used in protecting hot stored drinks (canned coffee) against flat sour spoilage, caused by thermophilic bacteria like Bacillus stearothermophilus.
Yes, combinations of emulsifiers are frequently used, they can work synergystically. Also sucrose esters are used to solubilise lecithin or to prevent mono-diglycerides transferring to the inactive β-crystalls.
Yes, Sisterna sucrose esters ensure very small oil droplets, which give a stable emulsion. Increasing the viscosity of the water phase, to improve stability, becomes unnecessary.
It is not necessary to choose a sucrose ester with similar HLB-value as the emulsifier you would like to replace. In most cases Sisterna SP70 or Sisterna SP50 are used to replace other emulsifiers. The dosage of Sisterna sucrose esters is usually (much) lower than the dosage of other emulsifiers. For the most appropriate sucrose ester type and dosage; please see our website or contact Sisterna.
In Europe and the USA sucrose esters are allowed in most product groups, these groups and maximum dosages are laid down in the EU and FDA regulations. You can find the regulations on our website.
Yes, you can choose between either putting sucrose ester (of fatty acids) on the package or emulsifier E473. For other languages please contact Sisterna for accurate information.
In very specific cases where sucrose esters are used as a processing aid in very low dosages there is an option not putting it on the ingredient declaration.
According to the ALBA-list there are no allergens in sucrose esters.
In the EU, sucrose esters are allowed in fine bakery but not in bread. Each country has its own definition of bread and bakery wares. For an overview, contact Sisterna.
Of course product data sheets and material safety data sheets. We are ISO, HACCP, Kosher, Halal and RSPO certified. There is an IP-statement proving non-GMO and all our grades are allergen free (ALBA).
In most countries Sisterna is represented, see http://www.sisterna.com/distributors/distributors-food/. If not, you can contact us directly for samples or enquiries.
The price depends on the grade of Sisterna sucrose esters and the order quantity. In most countries Sisterna is represented by an exclusive distributor. They can give an offer.
Sisterna has a warehouse in The Netherlands with stock for at least three months. Additionally our distributors have their own warehouse. In urgent cases we can airfreight product from the factory in Japan.
Yes, though we forward most sample requests to our distributors to ensure follow up. You can request your samples here.
Questions about sucrose esters in food?
Contact our experts: +31 (0) 165 524 735 or email us